RAMPS 1.4 Endstop Switch For RepRap Mendel 3D Printer With 70cm Cable

This end stop switch for 3D printers comes along with a 70cms cable wire. They are used together to detect when an X/Y/Z stage has reached its minimum or maximum in a 3D printer. The endstop switch for 3D printers is manufactured with a standard 4 pin 100? pitch header and also features an LED on the board that will light up when the switch is activated. 

It using 22AWG wire, copper wire inside is very thick, can be resistant to current 2A, 300V voltage. An insulating layer over a wide range of temperatures, up to 80 degrees. Is the common connection of thin copper wire can not match. Not easy to pull off, plug it convenient, for ease of use, plug the other side to do the one, you can use the direct plug.